Description
ZW-C102 conductivity sensor is mainly used to monitor the conductivity value in low conductivity aqueous solution. The conductivity sensor generates excitation signals at both ends of the internal and external electrodes, and collects the corresponding measurement signals according to the different conductivity of the liquid to be measured. The built-in vehicle gauge level intelligent chip outputs the conductivity of the liquid to be tested through the high-precision circuit and software algorithm, which has the characteristics of good stability, high measurement accuracy and strong anti-interference ability.
Application
Conductance value monitoring of pure water / RO water quality equipment, industrial water use, environmental water quality and other fields.
Features
Intelligent algorithm, anti-electromagnetic interference, analog output, excellent repeatability and stability, long service life, etc.
Specifications
| Parameter | Value |
|---|---|
| Model | ZW-C102 |
| Measurement Range | 0 to 20 μS/cm |
| Resolution | 0.01 μS/cm |
| Accuracy | ±1.5% F.S. |
| Operating Temp | -40 to 100 ℃ |
| Operating Pressure | <0.6 MPa |
| Power Supply | DC 24V (9V-36V) |
| Signal Output | 0.8V-4V (linear) |
| Wetted Material | SUS316L |
| Mounting | M22*1.5 / NPT 1/2 Thread |
| Power Consumption | ≤0.3W |
| Protection Level | IP68 / IP6K9K |
| Communication | Analog Voltage |
| Weight | 150±10g |
* The description and specifications might be changed without notice. Please contact us for the latest information before placing orders.
Technical Support:
Customized technical design and function, LOGO and package are available without extra charge (including molding fee) for mass volume.
The sensors don't have sleeping mode. It can be set in program if needed.
All Winsen products go through strict inspections and tests to make sure they are 100% qualified before shipping out.
The sensor has been fully tested (not calibrated) before leaving the factory, but the module will be calibrated before leaving the factory.
However, after transportation and storage, the environment conditions change, and the surface of the sensor absorbs moisture, mixed gas, pollution matters, etc. It is recommended that customers perform aging and calibration after sensors become stable according to the program and use occasions of the whole device.
15﹪-90﹪RH without condensation,greater or less than this range or long-term high temperature and high humidity will affect the life of the sensor.
Our sensors are certified with CE, 3C, ROHS, anti-explosion, fire prevention, and coal mining safety according to different applications. And we provide assistance for new certification.
Many factors can cause the sensor to fail such as broken wires in transportation, poisoning, falling off of the sensitive material, damage to the heating wire (device), etc. Please find specific cause in each category with Winsen’s aftersales.
Winsen provides professional consultation and service before and after sales. We will recommend the best fitting sensor for your demand. If you have any problem, don’t hesitate to email us to sales@winsensor.com
Due to high volume of daily incoming emails and time zone difference, we may not be able to reply your emails immediately. But we will reply to your inquiry in 24 business hours.
